Publish Time: 2022-12-03 Origin: Site
High speed veneer stacker is widely used in the production of veneer, and attention should be paid to the maintenance of high speed veneer stacker, so as to improve the production efficiency of the veneer stacker and extend the service life of the high-speed veneer stacker.
The lubricating oil used by high speed veneer stacker needs to be replaced regularly to keep the machine running smoothly and prevent instability caused by lack of lubrication during the operation of high speed veneer stacker. At ordinary times, pay attention to dedusting the surface of the high speed veneer stacker. Wipe it with a wet rag first. Don't miss the dead corners in the high speed veneer stacker, especially the cutting console. After it is wiped clean, it needs to be dried in time to prevent corrosion.
Also pay attention to check the circuit and wear of high speed veneer stacker, especially the wear of machine parts. If they are unqualified, they should be replaced immediately to ensure the normal operation of high speed veneer stacker.
In addition, we must correctly operate the high speed veneer stacker, and usually need to maintain the high speed veneer stacker, so as to prevent problems.
After using the high speed veneer stacker, clean the inside and outside of the machine. Wipe the outer wall of the washing machine and the stage with a wet rag to ensure its cleanness. Clean all the pipes with distilled water to prevent the crystal of the washing liquid from blocking the pipes. Discard the waste liquid in time to avoid the failure of high speed veneer stacker due to the reflux of the waste liquid caused by the overfilled waste liquid bottle. Note that the edge of the hole of the reaction plate to be washed shall not be too high and horizontal to avoid damage to the liquid aspirating needle.
Disassemble all parts of the high speed veneer stacker regularly for flushing to ensure smooth operation. Always unplug the power plug when you don't use the high speed veneer stacker.