Spindleless veneer peeling machine cutter blade installation and grinding method

      Veneer peeling machine is an indispensable mechanical equipment in plywood production. Its main function is to spin logs into thin veneers. It can be said that it occupies a very important position in the entire plywood production process. Under normal circumstances, veneer peeling machines can be divided into two types: spindle veneer peeling machine and spindleless veneer peeling machine.The difference between these two kinds of veneer peeling machine(rotary cutting machines) is that spindle veneer peeling machine are very advantageous when dealing with large-diameter logs. Now with the development of science and technology, the spindleless veneer peeling machine has also been born. When the spindleless veneer peeling machine is producing veneers, it not only improves the quality of the veneer, but also improves the precision of the rotary cutting. The production efficiency of the veneer is improved. Secondly, the spindleless veneer peeling machine can also process the remaining wood core produced by the spindle veneer peeling machine for secondary processing, and the remaining wood core is rotary cut into veneers of different thicknesses within a certain range of diameters.

      In the spindleless veneer peeling machine equipment, the most important component is its blade, which can directly affect the production efficiency of the veneer peeling machine(rotary cutting machine). Incorrect installation of the blade will also affect the use of the spindleless veneer peeling machine. Let's first understand the blade installation and grinding methods of the spindleless veneer peeling machine, and hope to help everyone!

When installing the blade of the spindleless veneer peeling machine, the height of the center line of the card shaft should be used as a reference, and the height of the two sides of the knife should be set by rotating the bolt, and then the middle height should be positioned, so that the blade edge of the blade and the center of the card shaft of the machine On the same level, then tighten the nut.

During the installation of the blade of the spindleless veneer peeling machine, it should be noted that the height of the blade edge is 0-1 mm higher than the center of the wood. If there is vibration during the rotary cutting, it is the installation of the blade of the spindleless veneer peeling machine. If the blade is too low, it is only necessary to adjust the blade until it does not vibrate the blade. If the resistance of the rotary cutting is too large or the skin is broken, it is because the blade of the rotary cutting machine without the card shaft is installed too high, and it can be appropriately lowered to the appropriate position.

The above content is about the introduction of the blade installation and grinding method of the spindleless veneer peeling machine. We must pay attention when installing the blade, because the blade directly affects our production efficiency. Necessary loss, I hope you read it carefully. If you want to know other friends about the knowledge of rotary cutting machine, please click to view the content of related articles!